A Designer Fabric Holiday Card


I ordered the new Designer Fabrics a long while back as part of a special for Stampin’ Up! convention attendees and was excited to try experimenting with incorporating fabric into my projects.  Well, I kept looking at the pretty fabric sitting on my shelf and couldn’t bring myself to cut into it (ok, and I’ll admit I was a little intimidated to try something different).  But after my friend kept asking me about the fabrics, I knew i needed to break them out and just start cutting!

So, this card was a fun way to play with the fabric, experiment with fraying the edges (since I had seen a few cards that did this to a very cute effect), and then also use the matching designer series paper as an accent in the Build-a-Brad.

Fabric Christmas Card smSide note – for those of you who have no idea what I’m talking about when i say “Build-a-Brad”, it is that brad in the center of the card.  What makes these brads cool, is that they come as a blank flat-topped brad.  They are meant for you to punch out any paper/stamped image using a 1/2” circle punch and adhere that punchout to the top of the brad.  Then you can use the provided clear  adhesive-backed plastic pebble to make the brad looked finished. 

Here is a close up of the brad showing how we punched out a circle from the Designer Series paper that had the same pattern as the fabric:

Build a Brad with fabric sm

I started with the idea of using the fabric and fraying it.  Then I added the Build-a-Brad.  I had the card done and all ready for the class when I looked at it and said, “Its so vintage, I bet a torn edge would look cool”.  So, I tore the bottom edge of the card, which looked cool but really popped when I added some Crumb Cake cardstock to the bottom of the card inside. 

This card probably took the longest to make, but I love its fun accents and vintage feel.

Some tips for this card:

  • When we adhered the DSP to the top of the brad, I like to use Crystal Effects as my glue as opposed to Snail or Glue Dots because you can get a flat even coating of the adhesive on the brad top and you know it won’t slide around on you in the future.
  • To adhere the fabric onto your cardstock, your best bet is probably going to be the Multipurpose Adhesive Sheets.  But if you don’t have that (and we didn’t for the class), you can use sticky strip to do the job.  For this card, I recommend cutting your fabric and determining where you are going to lay it on your card.  Cut a piece of Sticky Strip that is 1/2 – 2/3rd the height of your fabric piece and place it on the edge of the cardstock and then press your fabric onto the sticky strip.  I found that if you tried to put sticky strip directly onto the fabric, it can be hard to get the red backing off the tape without pulling the tape strip off of your fabric at the same time.
  • When fraying the edges of your fabric, only pull one or two threads at a time to minimize punching and pulling of your fabric. 
  • Pull extra threads for fraying by using the tip of your Paper Snips to separate the thread you are going to pull from the flat fabric piece.

Don’t miss your chance to get the Designer Fabrics for 50% off!

If you like the idea of playing with fabric in your projects, don’t miss your chance to try it out for half-off as part of the Online Spectacular sale.  You only have until Nov. 30th, so don’t delay!  Check them out HERE.


Leave a Reply

Your email address will not be published. Required fields are marked *